Wednesday, October 29, 2014

A modern twist...

...on the pour-over...the Z|E|V|R|O "Incred-A-Brew".


Got this from Bed Bath & Beyond for $20. Simple to use, easy to clean, and makes a good cup of coffee. I'll probably take this along on my next camping trip.

Saturday, October 25, 2014

There are some who say...

...the Aeropress is the easiest, bestest way to make coffee.

 
 
Aerobie Aeropress (stock photo)

Granted, it makes a good cup of coffee; what you won't get (regardless of what's printed on the box) is espresso.

Using the Aeropress as per the instructions will produce a coffee concentrate. You then dilute it with hot water, basically making an Americano. That's all fine and dandy, but my Fire King Jadeite D-handle mug is just the right size for this thing to make a good cup using just under one (Aeropress) scoop (which is about 15-17 grams, depending on whose article you're reading), as opposed to the 7 gram Bodum scoop I use for everything else (I've swapped scoops since this video was made). I fill my mug nearly to the top with cold water, dump it in my vintage Sona Ware J901 kettle, and light it up. While the water's heating, I place a filter into the filter holder and wet it. Using the inverted method will give you the best results, and is easier, that the "traditional" method. Stick the plunger section into the brewing chamber just to where the rubber part is completely inside, and turn the whole thing upside-down. Dump in your coffee (I use a medium-fine grind), and pour in just enough hot water to cover the grounds, letting it bloom for 10-15 seconds or so. Or, you can slowly pour in the whole pot, stirring as you go. Twist on the filter cap, and let it steep for as long as what meets your taste. I've been doing 30 seconds, with a 50 second plunge. Make sure you keep a good grip on this thing so it doesn't slip. Plunge away until you hear a soft *hisssss*; this means you've run out of water, and your brew is ready to enjoy. To clean, just twist the filter cap off (the paper filter and coffee grounds, or "puck", will remain in the chamber. Plunge the puck out into the trash and rinse it off. Don't leave the plunger's rubber part in the brewing chamber to ensure it will always fit tightly.


 As with any other method, it takes some trial and error and a bit of tweaking to get your brew to suit your taste. But I must admit...as old-fashioned, hard-headed, and resistant to change that I am, I'm beginning to like what this crazy thing is capable of.

Thursday, October 23, 2014

The simplest way to make (good) coffee...

...is with a pour-over. Among my various coffee makers is a vintage (c.1950s?) Melitta 101 3-hole cup-top "Kaffeefilter" in white ceramic.



Since size 101 filters are next to impossible to find here in the States, I use Melitta's #2 brown cone filters, and fold the side seam twice instead of just once. This gives the filter the correct diameter (or close enough, anyway). I wet the filter down with hot water to wash away any loose fibers, and to pre-heat it. Add two (7 gram) scoops medium-fine ground coffee, and slowly pour 10 ounces of water (just under boil), slightly stirring to keep the grounds good and saturated. Brews in about 3 1/2 minutes.

Tuesday, October 21, 2014

Although it's the same principle...

...all dripolators are not created equal...


"Genuine Drip-o-lator" 2-cup, Dunbar glass, possibly 1940's vintage

... but all are capable of making a great cup of coffee.


Wear-ever 3042 2-cup, early 20th Century ("TACU" stamped)

Like any other method (short of one using those silly little plastic cups or "pods"), it takes a little trial and error to get the right grind and coffee to water ratio to suit your own personal taste, but they're simple to use and the result is worth it.


"Best Made Extra Hard Aluminum" 6-cup

Great for camping, too, since no electricity is required. But, like I said before, there's little information on this particular style of brewer. But, fortunately, there are still some sites that strive to keep the memory alive...

"Guardian Consistently Good Coffee"

  1. Heat the beverage urn by rinsing with hot water.
  2. Place dripper in top of urn and put filter disc with seam side down in bottom of dripper.
  3. Measure into dripper, 2 teaspoons (1 level tablespoon, if a richer flavor is desired) of standard or drip grind coffee per cup. Do not use pulverized coffee*.
  4. Place water distributor over coffee, pressing down firmly but not tight.
  5. Pour in actively boiling water to desired measure. Use fresh cold water brought to a rolling boil. (Dripper is marked 2–4–6–8 cups.) For ten cups, measure proper amount of coffee in dripper, add eight cups of boiling water and when filtered thru, add 2 cups clear boiling water and mix.
  6. Cover and place over very low heat or on warm part of stove. Allow about 1 minute per cup for coffee to drip.
  7. When coffee has dripped thru, remove dripper, place cover on urn, adjusting cover with long flange in front of spout to retain heat.
 *Some espresso grinds may work, but pulverized varieties like Turkish or Greek coffee may leave a gritty finish

 Guardian 8-cup (aluminum lid, pre-war; glass lid, war era)

(Text & images courtesy The Guardian Service Ware Blog)


All of these particular styles require a separate kettle for heating and dispensing water. As far as I know (so far, anyway), only the Corning, with its ingenious control valve, does not. So, being the only coffee drinker in my household, I needed an equally-vintage kettle...


"Sona (Stratford On Avon) Ware" J901, 4-cup, made by NCJ, Ltd, possibly '50s vintage

Friday, October 17, 2014

My favorite method of brewing...

...is with a dripolator. Specifically, Drip-o-lator is a "patented coffee pot for making drip coffee". In this sense, it's most commonly seen stamped on the bottom of, well, dripolators made by the Enterprise Aluminum Company of Massillon, OH, or Macon, GA. A "dripolator" in general describes any coffee maker of that design; some use the term (as distasteful as it is) to include electric auto-drip machines and pour-overs, like the Chemex. Most dripolators are all aluminum, although many were aluminum uppers on top of a glass or ceramic kettle, or vice-versa...



I've haven't quite figured out what Corning pots are made of, but they work great.

A dripolator is nothing but two pots with the coffee in the middle. The upper pot has a perforated bottom and is filled with hot water, which drips into the "basket" containing ground coffee at a set pace. The basket has a more finely perforated bottom which again regulates the flow of coffee into the lower pot. And as with any other brewing method, the correct grind and coffee to water ratio will determine the outcome of the brew.


The "Wilbur" (Wilbur Curtis Co. LA63 2-cup "Coffee Saver")

Dripolators were popular from early- to mid-20th Century, to when the dreaded percolator took over as America's favorite method. I found it takes an awful lot of digging to come up with any real information on these things; Jitterbuzz has a good website with information on a wide variety of archaic coffee makers (and a bunch of other stuff). Like Wear-Ever, for instance...I found that the "TACU" stamp on the bottom dated the piece between 1901 and 1925.


Although dripolators share the same basic operation, there are variations in design. Some have a separate basket, while others incorporate it into the upper pot and use a spreader that's placed over the ground coffee to both evenly distribute the water while keeping the grounds from floating about (thereby thoroughly saturating them). Most require the use of a separate vessel for heating the water. However, the Corning (shown in the first photo) has a clever control valve (essentially a long-stemmed plug) that prevents water flow from the upper bowl. While the water heats in the kettle, the basket can be filled with coffee and attached to the bottom of the upper bowl. The control valve is inserted, heated water poured in, and the upper bowl then placed on the lower. Remove the control valve to begin the brewing process. Pretty nifty!


(Note: Should be "ground coarser", not finer. I get dyslexic at times.)

Dripolators can still be found in abundance on online auction sites, and for very reasonable prices. I look for completeness first; what good is a coffee pot if it doesn't have all the parts? Then, condition...cracked Bakelite handles, major dents or cracks, or nasty insides. Price is the least concern, although I'll spend extra time to find the best pot for the best buy. I'm willing to pay a little extra for an interesting piece. But every piece I buy has to be useable.

Wednesday, October 15, 2014

Remember what I said...

...about old and obsolete? Sometimes, those are the best. Take this little gem, for example...


 ...the Silex "2-cupper". A nifty little pour-over produced during the early years of World War II. See, back then, stuff was rationed as part of the war effort. Gasoline, flour, sugar...and coffee. At first, everyone over 15 years of age was limited to one pound every five weeks, beginning November 29, 1942. This amount was reduced to one pound every six weeks early in 1943. So, in order to stretch out one's coffee ration, Silex came out with the 2-cupper. As the name implies, only 1 or 2 cups were brewed at a time, instead of making a full pot (the usual amount was probably 8 cups). Fortunately, coffee rationing lasted only eight months.

 
The 2-cupper consists of two Pyrex bowls; the upper bowl containing a filter and a spreader, which holds the filter in place. This is placed on the lower bowl, which has a wooden handle attached. The filter and spreader are placed into the upper bowl, followed by the appropriate amount of coffee and hot water. As with any older Pyrex dish, it can be placed directly onto a gas stove to keep warm; a wire trivet must be used on electric stoves.


Since the original cloth filters are next to impossible to find, I use paper filters for a 4-cup basket-type auto-drip coffee maker. They're a bit over-sized, but once wetted, they can be formed to fit okay. I use the same medium-fine grind as I would with my Braun.


Just the right size for my 10-ounce cobalt mug. 

Saturday, October 11, 2014

As for myself...

...I'm both a collector and consumer. I try to collect the best usable examples I can find, without putting too big of a hole in my wallet. Actually, the first piece that got me started on my search for "the perfect cup" wasn't a collector's piece at all. It was a humble 4-cup auto-drip coffee maker, the Braun KF-12.  


I have a habit of buying stuff that soon becomes obsolete or discontinued (if it isn't already). Which is why I got this at half of what it retailed for (if I recollect, about $60; in the video below I think I said 2006, but my Coffee Geek review is dated June 2005). I think I bought the last one in existence, because they soon disappeared...and started showing up on eBay as "rare", "hard to find", and "vintage". In fact, there's one listed now going for $99.99, unused. I've been tempted to buy another, but since it's been going strong for over 9 years, why? It's not like I have nothing else to brew with. I reckon if it ever does go kaput, I'll take in for repair. It deserves a better fate than being stuck on a shelf.

 
The little Braun has, indeed, served me well. Water hits the grounds at 200 degrees, and I've used nothing but gold-mesh filters. I fill the tank up to the top of the "2" in the sight glass, which is the perfect amount for my trusty 10-ounce cobalt mug. Two 7 gram scoops of whole bean go into the Zassenhaus, medium-fine (I refused to use an electric grinder), flip the switch to "on" (the only control it has), and it brews in three minutes flat. I've been brewing this way, nearly every single day, for over nine years.

Friday, October 10, 2014

Welcome to the wonderful world...

...of coffee brewing. Here you'll find both the old and the new, the obsolete and high tech, the take-your-time and the quick-as-a-bunny methods of brewing the world's most-consumed commodity, coffee. That elixir that greets us each morning...that sweet addiction...the source of all that is, was, and ever shall be.


We'll be brewing with percolators and dripolators, French presses and AeroPresses, electricity and gas. We'll also be brewing with the latest and greatest toys, as well as 100-year-old pots. All for the sake of finding that perfect cup. We'll do a little historical background, too, and instructions on some of the old devices that have been long out of production. We'll discuss tips and tricks for getting the best cup of coffee with each method. Best of all, we'll enjoy a good cup of coffee.